7/31/2023 0 Comments Antminer u3 cgminer 4.9![]() Change the USB port which you connected your miner to. (When tested, HW error may occur if more than 2 units are connected to one PC) It is recommended to connect 2 units at most to one computer. run the miner one by one, if it is running ok then the miner is ok.stop mining, power off the miner, and wait for some seconds, start again.A: If you got some errors when mining, that’s normal.Q: I got many HW error when mining, why is that? And what can I do?.DON’T connect all the miners at one time. Important: you should connect the miners one by one to the USB-HUB.And the console will run both miners together. Then the black console will show some infomation about that another antminer U3 is detected.Then power on another miner, and connect it to the same USB-port the miner was connected before on the USB-HUB too. ![]() Power on one miner, then connect the miner to the same USB-port the miner was connected before on the USB-HUB.(But keep the USB-HUB connected to your computer.) Disconnect all the miners from the USB-HUB.Please remeber which USB-port on the USB-hub the miners were connected to.For example, if you connect 2 miners to a USB-HUB, then there will be two “CP2102 USB to UART Bridge Controller” in the list, you should choose each one and click “Replace Driver”. There will be several “CP2102 USB to UART Bridge Controller” in the list, choose each one and click “Replace Driver” (Or “Reinstall Driver”). Choose “Options->List all drivers”, and then in the pull-down list.Run the “zadig_v2.0.1.exe” in the software package you download.If your PC shows up “setting up the driver”, please wait it to finish.(Some USB-hub comes with an individual PSU, in that case, you should power on the PSU first.) Connect all the miners to the USB-hub, then connect the USB-hub to the USB-port of your computer.First, refer to the above, run each miner individually to confirm each miner works well.Here is the guide for how to mine with 2 miners with a USB-hub. METHOD 2: Use a USB-hub (Which is connected to your PC) to connect all the miners and run the miners. ![]() METHOD 1: Connect all the miners to the USB port of your computer, and run them together. ![]() There are two ways to run more than one miners together:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |